READ MORE: * How to build your own glasshouse * DIY project: build a trellised garden archway * DIY project: garden obelisk
1. To make the frame, use a saw to cut four pieces of the trellis beading to 1500mm and two pieces to 1400mm. For the rungs, cut 18 pieces to 400mm. Lightly sand any rough edges using a sander or sandpaper. Paint the 18 rung pieces with primer. Once dry, paint with your test pot colours of choice. Stainless Steel Balustrade
2.To make one half of the ladder, lay out two of the 1500mm frame pieces, with a shorter 1400mm length in the middle.
Lie the bottom rung across the frame so that it lines up with the base of the shorter middle frame piece.
Drill pilot holes and screw to the frame using a screwdriver.
Attach the top rung to the other end of the frame but instead of lying it across the frame, arrange it so that it is flush with the top of the frame. Drill pilot holes and screw in place.
3. Arrange the rest of the rungs using two 150mm offcuts of trellis beading as spacers so you can quickly space the rungs at even intervals.
Drill pilot holes and screw in place using a screwdriver.
Repeat this process for the other side of the ladder.
Stainless Steel Butt Hinges 4.Lie the two halves of the climbing frame together. To attach the hinges, lightly tap in the screws with a hammer, then screw the hinges to the top of the frame with a screwdriver.